1. Preparation – Cleaning
Ensure all surfaces are cleaned to remove any residual adhesives, oil and grease. Use LOCTITE® SF 790™ for easier removal of old adhesive residues. LOCTITE® SF 7070™ cleaner is recommended for general surface cleaning and degreasing prior to bonding.
2. Application
Use supplied nozzle and, where appropriate, cut the end to give the desired bead size. Dispense adhesive bead(s) directly onto the surface to be bonded or sealed; parts should be assembled immediately to prevent partial curing and shimming. Prevent the assembled parts from moving during cure. For large areas where both substrates are impermeable to moisture, do not cover the complete bonding area with adhesive – allow some gaps for moisture to penetrate the bond line. Any remaining gaps can be filled once the adhesive has cured.
Hints
Hold the nozzle at a 45° angle and pull along the bondline while applying dispense pressure. Test on a piece of scrap to find the appropriate speed that gives the required bead size. After assembling the parts, wipe away product squeezed out of the joint with a gloved finger or a finishing tool. Leave the nozzle on the cartridge after use to act as a sealing cap.
admin –
Sản phẩm dùng chất lượng, hàng giao đúng mô tả, shop tư vấn nhiệt tình. Mọi người mua hàng ủng hộ tại shop này nhá.
Mr Tom –
Sản phẩm nhìn đẹp, chất lượng tốt, giao hàng nhanh.
Anh Phong –
Shop tư vấn nhiệt tình, shop bán hàng vui vẻ, giao hàng nhanh, đóng gói đẹp.
Ms Dung –
Sản phẩm dùng tốt, đóng gói đẹp. Sẽ ủng hộ shop lâu dài.
Mc Kendy –
Giao hàng nhanh, đóng gói đẹp, chất lượng sản phẩm quá tốt.
Anh Bình –
Tư vấn sản phẩm rõ ràng, thái độ nhiệt tình, shop tận tâm tư vấn. Chúc shop mua bán nhiều thuận lợi.
Supplies Hà Tiên –
The product meets the requirements, good quality. Beautiful packaging.
Purchases Trường Thọ –
Quality products, enthusiastic advice, beautiful packaging, fast delivery.